== Steps for setting up the WiMAX BTS on ORBIT == Please note: Do not restart BTS until all changes are complete. If you do happen to restart, you will have to use the serial interface to connect to the BTS. * Change the IP address and correct configuration on the RF card. - Login to the BTS as root on 192.168.1.10/24 - Copy the attached [attachment:networkenv.orbit networkenv.orbit] file to /flash/networkenv - Use wiset commands below to correct configuration on the BTS: {{{ /usr/sbin/wimax/cmd_app 3 authgw_id 0x41534E4757303030 /usr/sbin/wimax/cmd_app 3 authgw_port 0x08B7 /usr/sbin/wimax/cmd_app 3 asngw_id 0x41534E4757303030 /usr/sbin/wimax/cmd_app 3 asngw_dp_port 0x08B7 /usr/sbin/wimax/cmd_app 3 asngw_ep_port 0x08B7 /usr/sbin/wimax/cmd_app 3 bs_rx_port 0x08B7 /usr/sbin/wimax/cmd_app 3 bsid 0x303030303030 /usr/sbin/wimax/cmd_app 3 frequency 2551500 /usr/sbin/wimax/cmd_app 3 bs_tx_power 40 /usr/sbin/wimax/cmd_app 3 bw_mode 0 /usr/sbin/wimax/cmd_app 3 dlul_ratio 2 /usr/sbin/wimax/cmd_app 3 ttg 296 /usr/sbin/wimax/cmd_app 3 rtg 168 /usr/sbin/wimax/cmd_app 3 framesync_mode 2 /usr/sbin/wimax/cmd_app 3 antenna_gain 0 # Other wiset commands changed to appropriately reflect new IP settings. /usr/sbin/wimax/cmd_app 3 authgw_ip 0x0A030047 /usr/sbin/wimax/cmd_app 3 asngw_dp_ip 0x0A030047 /usr/sbin/wimax/cmd_app 3 asngw_ep_ip 0x0A030047 }}} * Change settings on the N/W card. - Login to the N/W card at 192.168.1.42/24 again as root, and change the IP configuration for eth1 in the /etc/network/interfaces file as : {{{ auto eth1 iface eth1 inet static address 10.3.0.51 network 10.3.0.0 netmask 255.255.0.0 broadcast 10.3.255.255 gateway 10.3.0.1 }}}