Changes between Version 43 and Version 44 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

Timestamp:

Jan 11, 2013, 12:37:35 AM (11 years ago)

Author:

Ilya Chigirev

Comment:

—

Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

@@ -1 +1 @@
 [[TOC(Hardware/fAssembly, Hardware/fAssembly/LV67C*, depth=4)]]
 
-=== LV-67C Specifics ===
+===== LV-67C Specifics =====
 
 The assembling of new Gen 3 LV-67C based orbit node may have 3 major components.
@@ -10 +10 @@
 ----
 
-==== How to Assemble the Case ==== #CaseAssembly
+''' How to Assemble the Case '''
 
 There are a few considerations when it comes to the assembly of the LV-67C.
@@ -16 +16 @@
  2. Connect all the pig tails and route the wires to the right side (facing the rear) of the motherboard. 
 
-==== Flash The LV67-C bios ==== #Lv67cBios
-===== First Gen: =====
+''' Flash The LV67-C bios '''
+'''// First Gen: //'''
  1. Remove the lv-67c kit from it wrapping, Attach the pcm-cia and mini-pice cards (As [#CaseAssembly below]).
  1. Attach the video card assembly as [#PreviousCmosVideo prior]
@@ -37 +37 @@
  1. The bios is now configured. Reboot once more and check the serial console for bios boot messages. It should try to pxe from the leftmost interface (verify the mac address).
 
-===== Second Gen: =====
-The second batch of Lv67c motherboards do not need to have their bios flashed, only reconfigured.
+'''// Second Gen: //'''[[BR]] 
+The second batch of LV67C motherboards do not need to have their bios flashed, only reconfigured.
  1. Attach requisite cables and Cards[[BR]][[Image(AttachVideo2.jpg, 300)]] 
   * Serial Cable
@@ -75 +75 @@
  1. Depending on node type you will see an item labeled IBA GE slot xxxx v1324. Where xxxx is the hex address for the device (e.g. 0900 for Lan 1). Set this device to be !#1 in the boot sequence. Save and exit.[[BR]][[Image(BootSequence.jpg, 300)]]
  1. The node should now attempt to boot from pxe and if dhcp and tftp are setup correctly, the node should be able to boot into the pxe image. 
-