Changes between Version 9 and Version 10 of Internal/OpenFlow/SwitchConfiguration


Ignore:
Timestamp:
Feb 22, 2010, 4:37:01 AM (14 years ago)
Author:
akoshibe
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Internal/OpenFlow/SwitchConfiguration

    v9 v10  
    11= Miscellaneous Configurations =
    2 This is a compilation of notes/ remarks on configuration commands that were involved in trying to configure the IP8800 to work with the ORBIT network. A majority of configurations steps described here were either never done/undone after better configuration options were found. Nevertheless, since most of the documentations regarding the IP8800 is in Japanese, it seemed smart to keep an English record of these commands.
     2This is a compilation of notes/ remarks on configuration commands that were involved in trying to configure the IP8800 to work with the ORBIT network. A majority of configurations steps described here were never done, temporary, or undone after better configuration options were found. Nevertheless, since most of the documentations regarding the IP8800 is in Japanese, it seemed smart to keep an English record of these commands.
    33 
    44== Topics covered here ==
    … …  
    88 * Updating firmware - command `ppupdate`
    99 * DHCP/BootP relay agent and the IP Helper
     10 * Port mirroring
    1011
    1112== Undoing Configurations - And errors encountered ==
    … …  
    9697}}}　
    9798
     99== port mirroring (2/21) ==
    98100
     101Say that you want to monitor the traffic to/from a certain port. The switch can act as a network tap if you configure port mirroring. When configured to port mirror, the switch would send a copy of the frames it receives from certain ports to another port where you'd, say, connect a network analyzer.
     102
     103We needed to set up port mirroring to diagnose what was going wrong with the L2TP tunneling between the netFPGA hosts.
     104     
    99105
    100106