|Version 2 (modified by 4 years ago) ( diff ),|
Most of the info on this page is proprietary and confidential to the manufacturer. Do not distribute!!!
|2||AHC_PWR_EN||IN||Connect to DGND to turn off the antenna head, leave floating (or pull to 12V) to turn on antenna head|
|3||PAT_CLK_232||OUT||RS232 Levels, Antenna pattern change indicator|
|9||EXT_TX_232||IN||RS232 Levels, Switch antenna between TX and RX, also requires commands via the CMD interface|
To enable/disable the antenna from a Raspberry Pi or other microcontroller, the AHC_PWR_EN pin must be connected to ground through an NPN transistor as follows:
Serial port config: 115200bps baudrate, 8 bit data, no parity, 1 stop bit, no flow control
|Configure Power Amp||<addr>x<padrive>:<txgain>||drive: …|